V&T E5 Series User Manual page 49

4.4.4 Common Characters Displayed by LED
Except the parameters in first and second level menus, the operation panel will also display the following
characters as shown in the following table:
Prompt
symbol
Instantaneous display of inverter when
8.8.8.8.
inverter is powered on
−LU− Inverter DC BUS voltage too low
−dc− Inverter is in DC braking status
−At− Inverter is in motor data identification
bASE Basic menu (P0.0T=0)
The parameters are being downloaded and
CoPy
this symbol will be displayed
dEFt Restore to factory settings (P0.0T=T to 5)
E.XXX Fault is displayed. Refer to chapter 7
FASt Fast menu (P0.0T=T)
The parameter copy or upload function of
HoLd
operation panel is disabled
LASt Last changed T0 parameters displayed
LInE Communication of operation panel fails
If the symbol is not listed in the table, please contact the local distributor or manufacture.
36
E5 Series High Performance Universal Inverter
Meaning
Chapter 4 Operation Panel
User's Manual
Prompt
symbol
The parameters are being copied and this
LoAd
symbol will be displayed.
LocT Operation panel is locked
LocT Except M key, other keys are locked
Except RUN and STOPTRST keys, other keys
Loc3
are locked
ndFt Non factory setting parameters displayed
Password is cleared, see 4.5 for password
P.CLr
operation
P.SEt Password is set successfully
Prot Password protection is enabled
SLId Operation panel is identified as shuttle type
Press ESC+>>+
ULoc
panel
UpDn Operation panel is identified as key type.
Meaning
∨ together to unlock the