TECHTOP TD20 Series Product Manual page 74

TD20 Series VFD
Function
Name
code
P10 Group Simple PLC and multi-step speed control
Simple PLC
P10.00
means
Simple PLC
P10.01 memory
selection
Multi-step
P10.02
speed 0
The running
P10.03 time of stage
0
Multi-step
P10.04
speed 1
The running
P10.05
time of stage 1
Multi-step
P10.06
speed 2
The running
P10.07
time of stage 2
Multi-step
P10.08
speed 3
The running
P10.09
time of stage 3
Multi-step
P10.10
speed 4
The running
P10.11
time of stage 4
Multi-step
P10.12
speed 5
The running
P10.13
time of stage 5
Detailed instruction of parameters
0: Stop after running once. The VFD has to be
commanded again after finishing a cycle.
1: Run at the final value after running once. After finish a
signal, the VFD will keep the running frequency and
direction of the last run.
2: Cycle running. The VFD will keep on running until
receiving a stop command and then, the system will
stop.
0: Power loss without memory
1: Power loss memory; PLC record the running stage
and frequency when power loss.
100.0% of the frequency setting corresponds to the Max.
Frequency P00.03.
When selecting simple PLC running, set P10.02–P10.33
to define the running frequency and direction of all
stages.
Note: The symbol of multi-step determines the running
direction of simple PLC. The negative value means
reverse rotation.
P10.04
P10.02
ACC time
(2 stags)
P10.03 P10.05
multi-step speeds are in the range of --f
can be
TD20 series VFDs can set 16 stages speed, selected by
the combination of multi-step terminals 1–4,
corresponding to the speed 0 to speed 15.
DEC time P10.28
(2 stages)
P10.30
P10.06
P10.07 P10.31
max
-72-
Function Parameters
Default
value
0
0
0.0%
0.0s
0.0%
0.0s
0.0%
0.0s
P10.32
0.0%
0.0s
P10.33
–f
and it
0.0%
max
0.0s
0.0%
0.0s
Modify
○
○
○
○
○
○
○
○
○
○
○
○
○
○