Uc Command Reply Accept Character Control - Intermec EasyCoder C4 Reference Manual

UC – Command Reply Accept Character Control
This command specifi es a prompt acknowledge character
Description
which the printer returns on the RS-232 or USB channel to the
host after each command execution with no error reply before
proceeding with next command.
Syntax
UCp
Parameters p
1
Default is no Command Reply Accept Character (command
Remarks
UC0).
Parameter p
If command UC is activated, it will replace the <ACK>-character
at end of command
If error occurs and error report is activated, the error message will
be sent instead.
Example
Command
UC062
US
X50,200,5,400,20
↵
P
Intermec EasyCoder ESim v4.00—Programmer's Reference Manual
1
Specifi es the desired reply character by its ASCII decimal value (0-255).
If p is anything other than numerical characters or the value is zero, there will
1
not be any Command Reply Accept Character (default value).
saved in Flash.
1
US
Reply Comments
↵
>
↵
>
↵
>
>
Chapter 7—Commands
and P.
Set Command Reply Accept
Character to '>'
Reply error
Draw a box
Print box & reply '>' at ready
97