Using Rf Communications On The 2415 - Intermec Trakker Antares 2400 User Manual

Chapter 3— Operating the Terminals in a Network

Using RF Communications on the 2415

48
Make sure all components with antennas are at least 30 centimeters (1
foot) apart when power is applied. Failure to comply could result in
equipment damage.
Attention: Assurez-vous que la distance entre tous les éléments avec
antennes soit d'au moins 30 centimètres (un pied) avant de faire la
connexion avec l'alimentation électrique, faute de quoi vous risquez
d'endommager votre installation.
The 2415 has an internal antenna to transfer data using RF
communications. Before you can use RF communications, you need to
perform these steps:
1 Plan and prepare your network. For help, see the next section,
"Planning the Network Connection."
2 (UDP Plus or WTP network only) Configure the Intermec Gateway
or DCS 30X. For help, see "Configuring the Intermec Gateway or
DCS 30X" on page 49.
3 Configure the access points and radios. For help, see "Configuring the
Access Points" on page 50.
4 Configure the network parameters on each terminal in the network. For
help, see "Configuring the 2415 Network Parameters" on page 51.
5 (802.1x security) Configure the 802.1x security parameters on each
terminal in the network. For help, see "Configuring the 802.1x Security
Parameters" on page 52.
Note: You can also configure parameters for multiple terminals in your
RF network using the Wavelink Avalanche client management system
and the Intermec Settings application. For help, see Chapter 2,
"Configuring and Managing the Terminals," in the Trakker Antares
2400 Family System Manual (P/N 071389).
The set of network parameters you need to configure depends on whether
you install the terminal on the same subnetwork as the Intermec Gateway
or DCS 30X (UDP Plus or WTP) or host (TCP/IP) or on a different
subnetwork. For help determining which network parameters you must
configure, see "Configuring the 2415 Network Parameters" on page 51.
When you begin using the 2415, you need to understand how to use the
LEDs to monitor the RF communications. For help, see "Monitoring RF
Communications Using the Status LEDs" on page 56.
39 AGaramond
nugget
Trakker Antares 241X Handheld Terminal User's Manual