(2415 Only) Configure The Radio Parameters - Intermec Trakker Antares 2410 Quick Start Manual

C d 39 nuggetfont
If you are using a DHCP (Dynamic Host Configuration
Protocol) server, you can leave the default terminal IP address
as 0.0.0.0 to enable the 2415 as a DHCP client. For help, see
"DHCP (Terminal)" in the 2400 Family system manual.
To configure the Advanced Network parameters
Note: If the Intermec Gateway, DCS 30X, or host is
on a different subnetwork from the terminal, you
must configure the subnet mask and the default
router.
1 In the Subnet Mask field, enter the mask that is used to
separate the subnetwork address from the terminal IP address.
The subnet mask must be in the form n.n.n.n, where each n is
either 0 or 255. You must separate each n by a period.
ADVANCED NETWORK
Loopback: Disabled
Network Port: O5555
Subnet Mask:
255.255.255.0
Default Router
0.0.0.0.
Controller Connect Chk
Send Timer: 0035 sec
Recv Timer: 0060 sec
Retries: 07
more
2 In the Default Router field, enter the IP address of the
default router. The IP address must be in the form n.n.n.n,
where each n is a number from 0 to 255. You must separate
each n by a period.

(2415 Only) Configure the Radio Parameters

The 2415 communicates with a host computer in an RF
network either through access points and the Intermec Gateway
or DCS 30X or directly through the access points. All RF
devices that must communicate with each other must contain
the same radios. The terminal ships with one of these radio
options: WLI Forum OpenAir or IEEE 802.11b.
Trakker Antares 241X Handheld Terminal Quick Start Guide
241XG003.eps
13