Intermec Trakker Antares 2400 User Manual page 69

nugget
Trakker Antares 241X Handheld Terminal User's Manual
39 AGaramond
Note: Unlike TTLS security, LEAP security only requires the standard
2MB of memory on the terminal. It does not require the additional 4MB
memory option.
To enable 802.1x LEAP security on the terminal
1 Make sure that:
• your authentication server is properly configured. For help, see the
documentation for your authentication server.
• your Cisco access point is properly configured for LEAP security. For
help, see the documentation for your Cisco access point.
• your terminal is configured with the primary network, advanced
network, and radio parameters.
2 Configure your Cisco access point to communicate with your Trakker
Antares terminal using LEAP security.
Access the AP Radio Data Encryption screen. For help, see the
a
documentation for your Cisco access point.
Note: The AP Radio Data Encryption screen for your Cisco access
point may look different than the one shown here.
Check the Open check box for both Accept Authentication Type
b
and Require EAP.
Chapter 3— Operating the Terminals in a Network
55