Using The Suspend/Resume Key - Intermec Trakker Antares 2400 User Manual

nugget

Using the Suspend/Resume Key

Trakker Antares 241X Handheld Terminal User's Manual
39 AGaramond
Typing Characters on the Keypad
Position on the Keypad
Middle of the key
Left side above the key
Centered above the key
Right side above the key
You can also use the arrow keys to move the cursor around an application
screen. To go up or down the screen, press = or >. To go left or right,
press ( = or ( >.
Fld+ * Fld-
8
241XU003.eps
Typing Characters Using the Keypad
The Suspend/Resume key is the _ key in the middle of the bottom row of
the keypad. When you press _ to turn off the terminal, the terminal does
not actually shut off but goes into a Suspend mode. In Suspend mode, the
terminal continues to power all memory and turns off the power to most
of the hardware. This mode is referred to as "off" in the rest of this
manual.
When you press _ to turn on the terminal, the terminal either resumes
exactly where it was when you turned it off, or the terminal boots and
restarts your application. If you are using 802.1x security, the terminal
may reauthenticate before it starts your application. Resume is controlled
through the Resume Execution command. For help, see "Resume
Execution" in Chapter 6 of the 2400 Family system manual.
Note: The terminal displays the boot menu the first time you turn it on.
At the boot menu, press
terminal.
Even if you change the battery pack while the terminal is turned off, the
terminal resumes or boots the next time the terminal is turned on.
Chapter 1— Learning About the Terminals
Color To Type the Character
Press the key.
Orange
Press the orange
key.
Pink Press the pink
Green Press the green
8
to initialize the firmware and boot the
1
(
key, and then the
?
key, and then the key.
)
key, and then the key.
8
8
8
13