Intermec Trakker Antares 2400 User Manual page 35

nugget
Trakker Antares 241X Handheld Terminal User's Manual
39 AGaramond
To scan a bar code label with the scanner
1 Press _ to turn on the terminal.
2 Hold the terminal at a slight angle a few inches from the bar code label.
The scanner must be pointing toward the label.
3 Push the Scan button on the keypad. Direct the beam so that it falls
across all bars in the bar code label.
Note: If you are scanning a PDF417 label, point the terminal slightly
above or below the label and press the Scan button. Pass the beam over
the label in a steady sweeping motion. The 241X emits an audible
crackling sound indicating that the terminal is successfully scanning the
bar code.
When the terminal successfully reads the label, you will hear a high
beep.
*
B
0
2
4
1
8
*
The Good Read LED turns on when you successfully scan a bar code
label with the scanner or the input device that is connected to the
terminal. This LED turns off after 2 seconds unless you start scanning
another label.
Note: Some of the scanning options let you scan multiple bar code
labels without having to press the Scan button each time. For help, see
"Scanning Options" on page 22.
4 Release the Scan button.
Chapter 1— Learning About the Terminals
241XU011.eps
21