Wavelink Avalanche Update; 802.1X Leap Security Change - Intermec Trakker Antares 2400 User Manual

Wavelink Avalanche Update

802.1x LEAP Security Change

Trakker Antares Firmware Version 8.02 Addendum
The Wavelink Avalanche configuration package has been renamed. The
name has been changed from 24xxRCD.AVA to 24xxCFG.AVA.
802.1x LEAP security now requires Network EAP instead of Open as an
authentication type.
To enable 802.1x LEAP security on the terminal
1 Make sure that:
• your authentication server is properly configured. For help, see the
documentation for your authentication server.
• your Cisco access point is properly configured for LEAP security. For
help, see the documentation for your Cisco access point.
• your terminal is configured with the primary network, advanced
network, and radio parameters.
2 Configure your Cisco access point to communicate with your Trakker
Antares terminal using LEAP security.
Access the AP Radio Data Encryption screen. For help, see the
a
documentation for your Cisco access point.
Note: The AP Radio Data Encryption screen for your Cisco access
point may look different than the one shown here.
9