Learning About The Audio Signals - Intermec Trakker Antares 2400 User Manual

Chapter 1— Learning About the Terminals
Status LED Descriptions (continued)
LED Name Description
Network This LED tells you if the 2415 is connected to your network. The Network Connect status
Connect light may be off, blinking, or on.
Network Protocol
TCP/IP
UDP Plus
or WTP
When this LED is off, you are not connected to the network. Make sure the Network Activate
command is enabled and that the terminal is configured correctly for your RF network. Make
sure that you are in range of an access point.
In a UDP Plus or WTP network, this LED is not instantaneously updated, but does tell you
the communications status the last time data was sent or received from the terminal.
Modifier
This LED indicates that one of the modifier keys, such as a
another key, the key combination is available to the application. The Modifier LED turns off
unless the second key that you pressed is another modifier key that is different from the first
one that you pressed.
If Caps Lock is enabled, this LED remains on until you disable Caps Lock.
Battery This LED remains off when you have a charged battery pack in the terminal. The light turns
on when there is a low battery charge and the terminal is on. When the terminal beeps once
every 15 seconds, replace the battery pack with a charged battery pack or charge the battery
pack as soon as possible.

Learning About the Audio Signals

18
nugget
LED Off
Not
connected.
Not
connected.
The terminal has a beeper that provides you with audio feedback as you
use the terminal. For example, you hear a beep tone each time you enter or
scan a valid command. You can change the beep volume and the beep
duration to meet the needs of your working environment.
When you change the beep volume, you will also change the keyclick
volume if the Keypad Clicker command is enabled. The keyclick is the
sound you hear when you press a key on the terminal.
There are three ways to change the beep volume:
• Use the Backlight key (press ) +) on the keypad. Each time you press
) +, it makes the beep volume one level louder. On the 241X, there
are three beep volume levels including off. If the volume is at the
loudest level and you press ) +, the beep volume is turned off. If you
press ) + again, the volume changes to the quietest level.
Note: When you use this key to change the beep volume, these changes
are not saved permanently in flash memory.
39 AGaramond
LED Blinks
Nothing.
Connected to an access point,
but not to an Intermec
Gateway or DCS 30X.
,
is enabled. When you press
Trakker Antares 241X Handheld Terminal User's Manual
LED On
Connected to an
access point.
Connected to an
Intermec Gateway
or DCS 30X.