Intermec Trakker Antares 2400 User Manual page 103

TRAKKER Antares 2400 Menu System (continued)
saving changes, 33
starting, 28
troubleshooting
audio signals, list of, 18
bar code symbologies, 71
Boot Menu, using, 72
cannot see laser when Scan button is pressed, 70
CONFIG.SYS file, 68
configuring 802.1x security, 64 to 66
configuring the terminal, 60 to 63
DCS 30X, 69
error message
clone application, 63
EZBuilder application, 68
invalid application, 68
loading module, 68
PSK application, 68
screen, 68
Good Read LED will not turn off, 70
guide to finding solutions, 58
input device, 70
invalid DOS command, 68
lost network connection after suspend, 66
operating the terminal, 58 to 59
preventive maintenance, 74
pulse triggering not saved, 63
RF network communications, 66
running applications, 68
scanner will not read bar code label, 70
scanner works slowly, 71
scanning a configuration command has no effect, 61
scanning bar code labels, 70 to 71
Security ID command, 62
serial communications, 69
terminal emulation session cannot be established, 67
terminal locked up, 59
turning on the terminal using the _ key, 13
typing characters on the keypad, 12
TZ2410 Battery Charger, See battery chargers
U, V, W
UDP Plus network
illustrated, 40, 42, 44
parameters, listed, 51
terminal, checking the protocol loaded, 28
unpacking the terminal, 7
upgrading the firmware using the Boot Menu, 72
User Defined status LED, described, 17
VT/ANSI terminal emulation, See the TE 2000
VT/ANSI Terminal Emulation Programmer's
Guide
wands, connecting to terminal, 22
warm boot, 73
Wavelink Avalanche, using to configure the terminal,
See the Trakker Antares 2400 Family System
Manual.
what's new in this revision, 6
white keys, using, 13
Trakker Antares 241X Handheld Terminal User's Manual
wireless communications, See RF communications
WTP network
illustrated, 40
terminal, checking the protocol loaded, 28
X, Y
XMODEM protocol, described, 45
XMODEM1K protocol, described, 45
YMODEM protocol, described, 45
Index
89