Table of Contents
Advertisement
Secure the Power Cable
Secure the battery cable every 18 inches with adjustable cable clamps.
Work from the battery, toward the mounting area for the dock. Remove the
paper backing from a clamp and stick the clamp in place while drilling a
pilot hole with a #26 drill bit. Use #6 sheet-metal screws to permanently
hold clamps in place.
#6 Sheet-metal
Screw Goes Here
Fasten Ground Cable
The power cable connector has a ground strap (or wire) that must be fas-
tened to vehicle sheet-metal to ensure proper cable shielding. Follow the
steps below to fasten this ground strap:
1.
Drill a small hole where you intend to fasten the ground strap.
2.
Use a punch to dimple and enlarge the hole.
(Do not make hole too big for the screw.)
3.
Scrape a small circle of paint from around the hole.
4.
Use a #8 X 5/8" screw and flat washer to secure the strap.
SECTION 5
Use large clamp to secure op-
tional filter assembly
Figure 5-5
Secure Cable
Vehicle Installation
"
#8 x 5/8 Screw (w/washer)
Goes Here
Model 6600 User's Guide 5-9
Advertisement
Table of Contents
