Introduction To Vehicle Installation - Intermec 6600 User Manual

Introduction to Vehicle Installation

"
NOTE:
The vehicle installation kit allows you to wire the vehicle dock in a delivery
vehicle. Optional cables are available to mount the dock and a printer
nearby in the same vehicle. When the installation is complete, you will
have a secure place to store the computer between stops. In addition, the
vehicle electrical system provides power to recharge the computer and to
operate a printer (if one is installed).
During this installation, the power cable is wired directly to the vehicle bat-
tery. This direct connection reduces the chance of installation problems. It
also takes advantage of the natural filtering and regulating characteristics of
the vehicle battery.
Since each situation or equipment type may pose unique requirements,
mounting hardware selection and mechanical installation shall be the re-
sponsibility of the installer. Use nuts, bolts, and lockwashers for installing
the mount (adjustable swivel or fixed) for the dock: the mount is predrilled
with 3/16-inch holes.
A mounting bracket and bracket installation hardware is not provided in this kit.
This kit contains nuts, bolts, washers, a terminal ring, and a fuse link for
connecting the battery cable directly to the vehicle battery. It also contains
adjustable wire clamps to secure the cable in place.
Your tasks are to:
Route and install the battery cable.
"
Mechanically install the mount (provided by others).
"
Connect short cable(s).
"
Decide where you will mount the vehicle dock, then proceed with the fol-
lowing instructions.
SECTION 5 Vehicle Installation
"
Model 6600 User's Guide 5-3