Installing Cards; Removing Cards - Intermec 6600 User Manual

SECTION 3 Operation
"
PC Cards
"
NOTE:
"
NOTE:
3-2 Model 6600 User's Guide
General Information
There are two PCMCIA ("PC Card") slots located behind the PC Card door
at the upper end of the computer. Each card slot can accept one type II card,
or the lower slot can accept a type III card (this blocks the upper card slot).
SRAM memory cards may require their own internal battery. The PC Card battery
may have to be installed in such cards prior to use.
See the card manufacturer's literature for battery installation instructions and the
recommended replacement intervals.

Installing Cards

The upper card slot (closest to the display) is designated "drive B:\" while
the lower slot is designated "drive A:\."
Open the PC Card compartment door by turning the latch knob 1/4-turn
counterclockwise. Use a coin or flatblade screwdriver, if necessary to open
and remove the door. Then, slide the card, connector-end first, into the slot.
If you encounter resistance, remove the card, flip it over and try again. Re-
install the door and turn the latch knob 1/4-turn clockwise.

Removing Cards

Each slot has a card ejector device which you can reach by removing the PC
Card compartment door. The ejectors are located on the side of the PC Card
slot assembly. Press in on the ejector button to release and partially eject
the associated card. You can then grasp the card with your fingers for final
removal.