Table of Contents
Advertisement
3
Attach Mounting Base to Vehicle Dock
Perform the following steps, in the order given, to attach the mounting base
to the vehicle dock:
1.
Unscrew the large knob, as shown.
2.
Slide the long upper carriage bolt out of the assembly (do not mis-
place the spacer).
3.
Remove the dock mounting base from the mounting assembly.
4.
Attach the dock mounting base to the bottom of the dock with four
screws into the dock nutplate, as shown (see Figure 5-8).
5.
Postpone reattaching the mounting base and dock assembly until af-
ter the mounting pedestal is fastened in the vehicle.
SECTION 5
1. Large knob
2. Spacer
3. Carriage bolt
Figure 5-7
Remove Mounting Base
Vehicle Installation
"
1
2
Model 6600 User's Guide 5-11
Advertisement
Table of Contents
