Figure 3-10 Reinstall Dram Board - Intermec 6600 User Manual

SECTION 3 Operation
"
3-12 Model 6600 User's Guide
1. Align the DRAM board to the mating connector on the main board.
Press firmly until the board is seated in the connector and the other
end is snug against the standoff.
2. Discard the toothpick and reinstall the long screw to secure the
memory boards in place.
3. Reinstall the access panel (three screws).
4. Remove the grounding clip attached to the shroud around the stan-
dard PC card drive.
5. Replace the door on the PC Card compartment.
6. Reinstall the main battery.
7. Replace the battery compartment door and return the computer to
normal service.
1. Screw
2. DRAM board
Figure 3-10
Reinstall DRAM Board
1
2