Prepare Drive for Installation
Insert the PC Card device in the drive slot before installing it in the comput-
er. This cannot be done with the drive installed.
1. PC Card or device
2. PC Card drive
3. Connector
4. PC Card drive with card or device installed
Installation and Reassembly
In the following steps you will secure the PC card drive in the computer,
make electrical connections, and reassemble the computer. It may be neces-
sary to bend the ribbon cable at the connector so that the connector will line
up readily with the connector inside the computer.
1.
Place the drive (with PC Card device installed) in the computer, as
shown in Figure 3-6.
2.
Gently press the ribbon cable into the mating connector.
1
2
4
3
Figure 3-5
Install PC Card Device in Drive
SECTION 3
Operation
"
Model 6600 User's Guide 3-7