Mounting The Power Supply - Intermec Trakker Antares 2455 Installation Instructions Manual

Trakker Antares 2455/2475 DC Power Supply Installation Instructions
To wire a remote disconnect
1. Cut the positive (red) wire on the unterminated end of the fused power cable.
2. Wire the positive lead of the fused power cable through the ignition or to a remote
switch. Add additional wire as needed. If you are using a remote switch, mount the
remote switch in a convenient location on the vehicle.
Remote
switch
-
+
Vehicle battery
Connecting the Fused Power Cable to the Vehicle Battery
The fused power cable is approximately 46 cm (18 in) long and has quick-connects on
one end for attaching to the power supply input cable. The other end of the cable is
unterminated for connecting to the vehicle battery. Connect the fused power cable to
the battery so that the fuse is as close as possible to the vehicle battery or fused terminal
block. Make sure you connect the positive cable wires to the positive battery post and
the negative cable wires to the negative battery post.
The twist-lock in-line fuseholder holds one 3AB, 12A/125V fuse that provides short-
circuit protection. Install one fuse in the fuseholder; keep the second fuse as a spare.

Mounting the Power Supply

The power supply input cable is approximately 2.44 m (8 ft) long and can be shortened
as needed. The 2455/2475 power cable is approximately 1.8 m (6 ft) long and must not
be altered. Keep the cable lengths in mind when choosing the mounting location for the
power supply.
Caution
Do not attempt to lengthen the power supply input cable under any circumstances.
Conseil
Il ne faut, en aucun cas, tenter d'allonger le câble d'entrée du bloc d'alimentation.
Fused
power
cable
+ -
Fuse
24XXI006.eps
7