Figure 3-8 Remove Dram Board - Intermec 6600 User Manual

SECTION 3 Operation
"
3-10 Model 6600 User's Guide
5. Remove the single screw that secures the memory boards to the main
board. Drop a round toothpick (or similar object) into the hole to
keep the metal standoff (spacer) in place.
6. Use the bent end of a machinist's scribe to pry up under the corners
of the board near the connector. Grasp the foam pad and lift straight
up to remove the DRAM board.
7. When changing the FLASH board, remove the metal standoff
(spacer) that separates the DRAM board from the FLASH board.
8. Use the bent end of a machinist's scribe to pry up under the corners
of the board near the connector. Lift the FLASH RAM board straight
up. It is located beneath the DRAM board. Do not attempt to remove
the standoff (spacer) beneath the FLASH board. It is permanently
fastened to the main board.
4
Remove DRAM Board
1. Screw
2. RAM board
3. Standoff
4. FLASH board
Figure 3-8
1
2
3