SECTION 3
Operation
"
3-6 Model 6600 User's Guide
Install Internal PC Card Device
Follow the steps below, in the order given, to install an internal PC Card
drive and device. Note the distinction between "access panel" and PC Card
compartment door: you can open doors with a coin or flatblade screwdriver.
Access panels require a Phillips screwdriver to open. Read and observe all
precautions listed previously before proceeding.
Disassembly
1.
Place the computer on a grounded work surface.
2.
Attach the personal grounding device to yourself. This must be done
using an approved device such as a conductive wrist strap wired
through a 1 Megohm resistor to ground.
3.
Remove the PC Card compartment door and ground the shroud
around the card slots.
4.
Use a Phillips screwdriver to remove the internal PC Card access
panel (six screws).
Figure 3-4
Remove Access Panel