Table of Contents
Advertisement
Installation and Reassembly
1.
Hint: Place a round toothpick in the board mounting screw hole.
This serves as a pivot point to help align both boards during installa-
tion and will also keep the metal standoff in place.
2.
If changing FLASH, install the new FLASH RAM board by aligning
it to the connector on the main board. Press firmly until the FLASH
RAM board is snug against the mating connector and the fixed stand-
off.
3.
Place the metal standoff over the toothpick in the hole in the FLASH
board.
1
SECTION 3
À À À
1. FLASH board
2. Standoff
3. Connector (for FLASH board)
Figure 3-9
Install FLASH Board
Model 6600 User's Guide 3-11
Operation
"
2
3
Advertisement
Table of Contents
