B
CAUTION:
Memory Installation Procedures
Follow the steps below, in the order given, to remove the DRAM and the
Flash RAM cards. Read and observe all precautions listed previously be-
fore proceeding.
Disassembly
1.
Place the computer on a grounded work surface.
2.
Attach grounding device to yourself. This must be done using an
approved device such as a conductive wrist strap wire through a 1
Megohm resistor to ground.
3.
Remove the PC Card compartment door and ground the shroud
around the card slots.
4
3
Do NOT allow screws, metal fragments, or other metal hardware to fall into the
computer once the access panel has been removed
4.
Use a Phillips screwdriver to remove the three screws that secure the
memory board access panel. Set the screws and the panel out of the
way.
1. Access panel
2. Attach grounding clip to metal shroud
3. Remove main battery pack
4. RAM board
Figure 3-7
RAM and FLASH Access
SECTION 3
Operation
"
1
2
Model 6600 User's Guide 3-9