Battery Cable Connections; Cut And Strip The Battery Cable; Figure 5-1 Strip The Battery Cable - Intermec 6600 User Manual

Intermec 6600: user guide

Hide thumbs Also See for 6600:

Table of Contents

Battery Cable Connections

Î Î Î Î Î Î Î Î

P/N: 206-953-009

Î Î Î Î Î Î Î Î

P/N: 216-964-009

Battery Cable Completion

You must cut the cable to length, cut off a portion of the outer cable jacket

and strip the individual wire ends of the cable. (Note: you may end up

shortening, and restripping, the red wire when attaching the fuse link).

Then, you must install a preassembled in-line fuse link in series with the red

wire and install a terminal ring on the black wire. Finally, you must me-

chanically complete the connections to the vehicle battery.

Cut the gray battery cable near the battery.

Strip the cable jacket back 12–14 inches.

Strip 1/4" of insulation from the black wire.

Gray Battery Cable

Strip the Battery Cable

SECTION 5

Red Wire

Black (or Brown) Wire

Strip the Cable Jacket

12–14 inches

Figure 5-1

Vehicle Installation

Strip each wire end

1/4 inch

Ç Ç

Model 6600 User's Guide 5-5

Table of Contents