Figure 5-9, Vehicle Dock - Intermec 6600 User Manual

Attach Dock to Mounting Bracket
You can now reattach the mounting plate and dock to the mounting bracket
and post assembly. If clearances are tight at the rear of the dock, make elec-
trical connections first.
1. Align the dock mounting plate holes to the corresponding holes on
the mounting post.
2. Install the long carriage bolt from the right side (when looking at the
front of the dock) and slide it through all four holes.
3. Place the spacer on the protruding end of the long carriage bolt. (left
side as you face the front of the dock)
4. Screw the large knob onto the long carriage bolt.
5. Tilt the dock to suit your needs.
6. Securely tighten the large knob to secure the dock in place.
7. You can loosen all knobs to adjust the dock.
8. Tighten all knobs securely to maintain the desired adjustments.
4
3
SECTION 5
1. Swivel adjust
2. Height adjust
3. Mounting holes
4. Tilt adjust
Figure 5-9
Vehicle Dock
Model 6600 User's Guide 5-13
Vehicle Installation
"
1
2