Default mode
Language
Enable Password Protection
Test Data
Restore Defaults
Print Configuration Lists
10-24
System Setup: System Setup
This is the operating mode the unit defaults to after power-up:
[Automatic].
To select the language.
Select Yes to protect the setup menu with a password. You will be asked
to enter a password and to repeat it. Then password protection is active.
To change the password (only possible when password protection is
active), do the following.
1. Select menu item Enable password.
2. Enter the old password.
3. Enter the new password.
4. Repeat the new password.
Used for demonstration purposes (yes). It should be set to [no] (default)
for proper clinical use.
Selecting Yes will restore the factory default settings (including the
defaults of the three operating modes).
The electrocardiograph must be switched off and on again for the new
settings to become effective.
Selecting Yes will display a menu with all available configuration lists.
All lists
System Setup/Communication/Peripheral Devices/Patient Data
MAC 1200/1200 ST
2012250-021
Revision C