GE MAC 1200 Operator's Manual page 116

8-20
Stress Tests: Running a Stress Test
During the test you can do the following.
Change the load in 5-Watt increments with
with all bicycle ergometers), or change the speed in steps, or
deactivate the automatic load increase with
Change the treadmill grade in 0.1% increments with
Advance to the next stage with
Advance to the next phase with
Start and stop the treadmill with
Initiate additional report printouts with
Change the gain with
Stop the test with
127(
When you press
and the phase name is given as Manual. For safety reasons, the
program maintains the current stage and the
You can only control the test manually with the
buttons (speed, grade). When you push
to the next stage and a stage report is printed. With
advance to the next phase.
At the end of each load stage and, if configured, with the ECG interval,
the recorder prints a 12-lead report and the median complexes of all 12
leads, including the ST measurement results.
Depending on what was selected in the Setup menu, this is either a
Comparative Medians Report or a Medians Report.
127(
If the unit runs out of paper during the test, a message informs you
of the problem. After inserting new paper, acknowledge the message
with . Do NOT press
MAC 1200/1200 ST
2012250-021
, ,
, ,
Start
Stop
, .
.
.
mm/mV
.
or , the program enters the manual mode
, the program increments
; this will abort the test.
(not possible
.
Alt
,.
.
.
button is inactive.
Alt
and
you
Revision C