GE MAC 1200 Operator's Manual page 107

Revision C
Stress Tests: Ergometers with Remote Start Pulse
5. When you press
and the phase name is given as "Manual"
For safety reasons, the program maintains the current stage and the
buttons and
Alt
manually with the buttons
6. When you press
a stage report is printed. With
With the EC1200,
to the preceding stage without generating a stage report. After a load
change, wait until the new load appears in the display before you
activate one of these buttons again.
When the number of revolutions is low, the EC1200 will
automatically activate a load of 15 Watts and increase the load to the
old value when the speed picks up again. During that time, the
buttons ,
proceed to the next load stage.
1
Does NOT apply to the EC1200.
MAC 1200/1200 ST
2012250-021
or , the program enters the manual mode
1
.
are inactive. You can only control the test
.
, the program increments to the next stage and
you advance to the next phase.
takes you to the next higher stage and
, are inactive and the program will not
1
8-11