Running A Stress Test - GE MAC 1200 Operator's Manual

Running a Stress Test

8-18
Stress Tests: Running a Stress Test
1. Press . This enables the passive mode.
2. Select the test protocol via
3. Enter patient data via
4. Apply the electrodes.
5. Initiate the stress test with
record the 12-lead ECG. At the same time, the unit learns the
patient's typical QRS complex. From this QRS complex, the unit
derives the median complex which is the reference beat for
calculation of the ST level and slope during the test.
The locations of all relevant device settings are shown below:
Operating mode Muscle filter
2
Report function
Selected exercise test
Phase
Stage
Failure message
Stress Test Screen, Bicycle Ergometer
1. if enabled
2. or REC OFF when the recording function is disabled
3. if any
MAC 1200/1200 ST
2012250-021
.
.
. The MAC 1200 ST will first
1 1
AC line filter Anti-drift system
Gain
Three leads
display here
Time since onset of test
Time in phase
Time in stage
3
1
"Patient Name"
Report sequence
Load RPM
PVC/min
Current HR, [HR Limit]
Revision C