Status Signals - Otto Bock Kenevo 3C60 Instructions For Use Manual

LED LED on Battery char­
on battery ger connec­
power char­ ted to product
sup­ ger
ply
The
LED
turns off
or
change­
s colour
at irreg­
ular
inter­
vals
Beep signal
4 x short at intervals
of approx. 20 sec.
(continuously)

14.2.3 Status signals

Battery charger connected
LED on LED on
power battery
supply charger
Battery charger disconnected
Beep Vibration
signal signal
1 x short 1 x short
–
3 x short
90
Error
Yes Temperature of the battery
charger too high
Error
Charging the battery outside the
allowable temperature range
Event
Power supply and battery charger operational
Event
Self-test completed successfully. Product is operational.
Maintenance note
Conduct the self-test again by connecting/disconnecting the battery
charger. If the beep signal is emitted again, you should visit the O&P
professional soon. If necessary, they will forward the product to an
authorised Ottobock Service Center.
The product can be used without restrictions. However, vibration signals
may not be generated.
Resolution
The distance between the
battery charger and the
receiver on the knee joint
must not exceed 1 mm. If this
distance is too great during
the charging process, the
magnetic surface of the bat­
tery charger can heat up and
interrupt the charging pro­
cess.
Take the battery charger off
the knee joint, disconnect it
from the power supply and let
it cool down. If the error
recurs, the battery charger
must be inspected by an
O&P professional.
Resolution
Check whether the specified ambi­
ent conditions for charging the bat­
tery are met (see page 84).