Error Messages While Establishing A Connection With The Remote Control App; Status Signals - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Error message
NO NEW DEVICE FOUND

15.2.4 Error messages while establishing a connection with the remote control app

Error message
DEVICE NOT FOUND
Component was connected
to another device. Establish
connection?

15.2.5 Status signals

Battery charger is connected
LED on LED on
power sup­ battery
ply charger
Battery charger disconnected
Beep sig­ Vibration
nal signal
1 x short 1 x short
Battery charge level
Battery
charger
Battery is being charged, battery charge level is less than 50%
C-Leg 3C98-3/3C88-3
Cause
No new prosthesis could be
found since this prosthesis is
already stored.
Cause
The connection could not be
established as no component
with the entered serial num­
ber could be found.
The component was connec­
ted to another device/remote
control
A current connection to the
prosthesis was interrupted
Event
Power supply and battery charger operational
Event
Self-test completed successfully.
Correction
• Distance from the prosthesis to the remote con­
trol
• Was the prosthesis connected to another
remote control?
The connection that was already saved in the
remote control must be deleted in order to re-
connect the prosthesis to this remote control. A
new connection from the prosthesis to this
remote control must then be established (see
Page 72).
• Use the key to confirm the error message,
then try to establish the connection again.
1) Confirm error message with the
2) Use the , keys to select the menu option
"SELECT DEVICE" and confirm this with the
key.
3) Use the , keys to select the prosthesis you
want and confirm this with the
Correction
Compare the serial number entered with that of the
component, then try to establish the connection
again.
To disconnect the original connection, tap the "OK"
button.
If the original connection is not to be disconnected,
tap the "Cancel" button.
Check the following points:
• Distance from the prosthesis to the device
• Battery charge level of the prosthesis
• Bluetooth on the prosthesis switched on? (see
Page 86)
• Prosthesis switched on? (see Page 86)
• If multiple prostheses were stored in the remote
control, was the correct prosthesis selected?
Appendices
key.
key.
Ottobock | 93