Status Signals - Otto Bock Genium X3 Instructions For Use Manual

Appendices

17.2.4 Status signals

Battery charger connected
LED on Status LED
power sup­ on battery
ply charger
Battery charger disconnected
Beep sig­ Vibration
nal signal
1x short 1x short
3x short 3x short
5x long 5x long
(every
minute)
Battery charge level
During the charging process, the current battery charge level is indicated by the number of LEDs lit on the side of
the charger.
LEDs 0
Battery charge 0%-10%
level
58
Event
Power supply and battery charger operational. Battery charger not yet connected to
receiver.
Battery charger connected to receiver, good connection.
This display turns off automatically after approximately one minute to avoid bother­
some light at night. The charging process is not affected.
Event
Self-test completed successfully. Product
is operational.
Maintenance note:
E.g.: Maintenance interval
exceeded, temporary
sensor signal
AXON tube adapter not connected while
removing inductive charger
1 2
10%-30% 30%-50%
Resolution
• Use the Cockpit app to check the next
has been
maintenance date for the prosthesis
disruption of a
(see page 43). If the date has been
reached or exceeded, the prosthesis
and tube adapter, battery charger and
power supply have to be sent to an
authorised Ottobock Service Center.
• Conduct the self-test again by con­
necting/disconnecting
charger.
• If the beep is emitted again and the
maintenance
reached or exceeded, the prosthesis
should be inspected by an authorised
Ottobock Service Center.
• The product can be used without
restrictions. However, vibration sig­
nals may not be generated.
• Connect the AXON tube adapter and
then restart the knee joint by connect­
ing/disconnecting the battery charger
• If the beep/vibration signal recurs, the
product must be inspected by an
authorised Ottobock Service Center.
3
50%-70%
Genium X3 - Bionic Prosthetic System 3B5-X3/3B5-X3=ST,Ge­
the
date has not
4 5
70%-90% >90%
nium X3 3B5-2/3B5-2=ST
battery
been