Walking Down A Ramp; Walking Backwards; Using A Bicycle Ergometer - Otto Bock Kenevo 3C60 Instructions For Use Manual

8.3.8 Walking down a ramp

8.3.9 Walking backwards

8.4 Using a bicycle ergometer

Prerequisites for activating the "Bicycle ergometer" MyMode
• A bicycle ergometer is required. Switching is not possible for recumbent bicycles or so-called
pedal trainers.
• The bicycle ergometer must have a freewheel.
• The user must be in the sitting position.
• The sitting position must not be too high, otherwise the knee is extended during the pedaling
movement, ending the MyMode.
• The sitting position must not be too low. Note the permissible flexion range of the knee joint.
• The feet have to be positioned on the pedals.
• Pedaling movements must be possible.
Activating the "Bicycle ergometer" MyMode (activity mode A, B, B+)
1) Sit on the bicycle ergometer with the leg extended.
2) Hold the leg horizontally until the knee joint flexes on its own due to gravity.
3) Put the feet on the pedals and perform pedaling movements within one minute, or activate the
"2.Bicycle ergometer" MyMode using the Cockpit app.
→ After a few pedaling movements, these are recognised by the knee joint and a short beep
and vibration signal is produced. If this signal is not produced, the time limit for position­
ing the feet on the pedals (one minute) was exceeded or the prerequisites for activating
this MyMode are not met.
→ The short beep and vibration signal is produced periodically at intervals during the pedal­
ing movement until the resistances in the flexion and extension direction have been
reduced to the extent that the knee joint moves freely.
Under increased flexion resistance, permit controlled flexion of the knee joint
which lowers the body's centre of gravity.
The swing phase is not triggered even though the knee joint is flexed.
While walking backwards, the hydraulics keep the knee joint stable with high
flexion resistance.
The "Bicycle ergometer" MyMode allows a bicycle ergometer to be used
without exiting the currently selected activity mode.
Note the prerequisites for switching and the differences for activation in the
respective activity modes.
77