Status Signals - Otto Bock Genium 3B1-3 Instructions For Use Manual

Error message
Mode change failed

16.2.4 Status signals

Battery charger connected
LED on Status
power LED on
supply battery
charger
Battery charger disconnected
Beep Vibration
signal signal
1x short 1x short
Cause
An attempt was made to
switch to a different
MyMode while the com­
ponent was in motion
(e. g. while walking)
A current connection to
the component was
interrupted
Event
Power supply and battery charger operational. Battery charger not yet
connected to receiver.
Battery charger connected to receiver, good connection.
This display turns off automatically after approximately one minute to
avoid bothersome light at night. The charging process is not affected.
Event
Self-test completed successfully.
Product is operational.
Correction
For safety reasons, switching MyModes is
only permitted when components are at
rest, e. g. while standing or sitting.
Check the following points:
• Distance from the component to the
device
• Charge level of the component's bat­
tery
• Bluetooth of the component switched
on? (Switching Bluetooth of the com­
ponent on/off)
• Hold the component with the sole of the
foot facing up to make the component
"visible" for 2 minutes.
• If multiple components were stored,
was the correct component selected?
Resolution
49