Turning Bluetooth On The Prosthesis On/Off - Otto Bock Kenevo 3C60 Instructions For Use Manual

Parameter
Intuitive stance func­
tion¹
Intuitive bicycle
ergometer function¹
Wheelchair function¹ 0/Off – deac­
Sitting function¹
Donning function
¹ To use these functions in the Cockpit app, they need to be enabled or turned on in the adjust­
ment app.

8.7 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see page 80).
Switching off Bluetooth
1) With the component connected, tap the
→ The navigation menu opens.
2) Tap the "Functions" option in the navigation menu.
3) Tap the "Deactivate Bluetooth" option.
4) Follow the on-screen instructions.
Switching on Bluetooth
1) Turn the component over or connect/disconnect the battery charger.
80
Adjustment Cockpit app
software adjustment
range range
0/Off – deac­ 0/Off – deac­
tivated tivated
1/On – activ­ 1/On – activ­
ated ated
0/Off – deac­ 0/Off – deac­
tivated tivated
1/On – activ­ 1/On – activ­
ated ated
0/Off – deac­
tivated tivated
1/On – activ­ 1/On – activ­
ated ated
0/Off – deac­ 0/Off – deac­
tivated tivated
1/On – activ­ 1/On – activ­
ated ated
0/Off – deac­ 0/Off – deac­
tivated tivated
1/On – activ­ 1/On – activ­
ated ated
Meaning
Information about this function is
provided in the section "Stance func­
tion" (see see page 74)
Information about this function is
provided in the section "Using a
bicycle ergometer" (see see
page 77)
Information about this function is
provided in the section "Using a
wheelchair" (see see page 78)
When the function is activated, the
resistance in the flexion direction
while sitting is reduced in addition to
the reduction of resistance in the
extension direction.
If the knee joint is not loaded for a few
seconds after disconnecting the char­
ger, the prosthesis can be flexed.
Flexion makes putting on the pros­
thesis easier. Ending knee flexion or
loading the prosthesis immediately
reactivates the configured operating
state. This function can be activated in
mode A, B or B+.
icon in the main menu of the Cockpit app.