ZOE PPM3 User Manual page 36

Getting Started
The serial port is configured as follows:
Baud rate
Data bits
Stop bits
Parity
Flow Control
To connect the PPM3 to an Electronic Medical Record (EMR) system:
1. Connect the Network Cable to the connector labeled
of the PPM3. Then plug the other end of the Network Cable into PC that
is hosting the EMR software.
Note: For complete details of the communications protocol the PPM3 uses for
interfacing with EMR systems, please refer to the document "PPM3 Data Transfer
Interface" (Part Number 122-0064).
Connecting to the Nightingale MPC Central Station
Connection to the Nightingale MPC Central Station requires a custom Network
Cable from Zoe Medical (Part Number 421-0053).
To connect the PPM3 to a Nightingale MPC:
2. Connect the Network Cable to the connector labeled
of the PPM3. Then plug the other end of the Network Cable into the wall
plate connector marked "Nightingale Monitoring System."
2-8
38400
8
1
None
None
N i g h t i n g a l e P P M 3 U s e r ' s G u i d e
on the right side
on the right side
April 2019