Table of Contents
Advertisement
Overview
You can use the PRINT key to generate a Vital Signs Report at the printer that is
connected to the Nightingale MPC central monitoring station, or store a Vital
Signs Report while the PPM3 is disconnected from the Nightingale MPC. When
the Strip Chart Recorder Option is installed, pressing this key initiates a strip chart
recording.
You can use the ALARM SILENCE key to silence alarm tones when they are
annunciating, and also to remove messages that are being displayed after you
have read them.
You can use the NBP INTERVAL key to change the interval between NBP
measurements in Interval Mode (as well as to enable/disable NBP Interval Mode
– see the NBP Monitoring chapter for more details).
You can use the NBP START / STOP key to start a NBP measurement, if one is
not currently running, or to stop a NBP measurement, if one is currently running.
You can use the STANDBY key to place the monitor into Standby Mode, or
when you are preparing to transport or discharge a patient.
You can use the SETUP key to bring up the menus used to change settings for the
monitor.
You can use the TRENDS key to bring up the trend display.
You can use the MAIN SCREEN key to return to the normal Main Screen
display.
You can use the control knob to navigate the PPM3 menus. Turn the knob to the
left to navigate to the left or up. Turn the knob to the right to navigate right or
down. Press the knob to select a highlighted menu item.
1-9
April 2019
N i g h t i n g a l e P P M 3 U s e r ' s G u i d e
Advertisement
Table of Contents
