Table of Contents
Advertisement
4.0 Setting Up the LiteLift® PRO
4.1 Unpacking the LiteLift® PRO
Remove all the LiteLift® PRO CPM system components from the carton. During unpacking, make sure that all components
are present and that there is no external damage. Report any substantial damage.
Fig. 1
LiteLift®
PRO Device
with all
components
4.1.1 Included in your Kit
1 Motion unit
1 Power Adaptor
1 Power cord
1 PRO Pendant Controller
1 Pendant Cable
1 Long Footbar
2 White Foam Pads
1 Patient Kit
1 Foot Plate
1 Thigh Support Bar
1 Calf Support Bar
1 Instructions for Use
Note!
Save packaging for storage when the device is not in use. Additionally, if it is ever necessary to return for service,
this packaging provides all the protection that is required under warranty.
BEFORE USE
1. Allow device to reach room temperature for a minimum of one hour prior to use.
2. Tighten all knobs and fasteners.
3. Before patient use, verify the Range Of Motion (ROM) settings by operating the CPM through one full cycle.
4. Ensure that both Power Cord and PRO Controller Cable are uncoiled from the device.
Attention!
Service should be performed only by qualified technicians. Training is available through the manufacturer.
7
Advertisement
Table of Contents
