Attaching Thigh And Calf Support Bars - Otto Bock 7000P Instructions For Use Manual

Step 3: Loosen and push down on the Thigh Length Adjustment Knob (Fig. 17, Pos. 5) while pulling up on the Thigh
Bar (Fig. 17, Pos. 4) to set the distance between the device knee axis and the device hip axis EQUAL to the
distance measured between the patient's greater trochanter and knee center in Step 1.
Step 4: Re-tighten the Thigh Length Adjustment Knob.
IMPORTANT NOTE: The device will not operate if the Thigh Length Adjustment Knob is not tightened securing
alignment. An error code will occur requiring you to turn the device off and on again to re-set.
5.2 Attaching the Thigh and Calf Support Bars
Fig. 18
1. Sling
2. Pad
3. Paddle
4. Sling Clip
5. Support
Bar
The Thigh and Calf Support Bars and Paddles, in conjunction with pads and slings, support the patient's leg during CPM
use and can be used on both left and right legs (Fig. 18).
Fig. 19
1. Loosen Knob
2. Retract Knob
3. Apply or
Remove Paddle
Attach Paddles to the Thigh and Calf Support Bars by loosening and pulling ridged knob on Support Bar (Fig. 19).
Retighten once Support Bar is positioned properly.
14
å ç é
é
è ê
å
ç