Patient Alignment And Setup; Aligning The Knee And Hip Axis - Otto Bock 7000P Instructions For Use Manual

5.0 Patient Alignment and Set Up
Fig. 16
THIGH SUPPORT BAR
ADJUSTMENT KNOB
THIGH SUPPORT BAR
THIGH LENGTH
ADJUSTMENT KNOB
THIGH BAR
PRO CONTROLLER
PENDANT
HIP AxIS OR
HIP JOINT
Danger!
Always fully support CPM when lowering device to bed.
Danger!
Always reengage Clutch Release Lock after lowering device to bed.
With the patient in the supine position, release the safety strap (if attached) and gently lower the LiteLift® PRO over the
patient's limb according to directions in section 4.3.3. Make sure that the LiftLift is completely supported by the bed (you
may have to adjust the double clamp to do so). Also make sure that the Clutch Release Lock is correctly engaged.
5.1 Aligning the Knee and Hip Axes
Fig. 17
1. Calf Support Bar
Adjustment Knob
2. Knee Axis
3. Thigh Support Bar
Adjustment Knob
4. Thigh Bar
5. Thigh Length
Adjustment Knob
6. Hip Axis
Step 1: Measure the distance between the patient's greater trochanter to knee center.
Step 2: With the patient supine (lying down) and the LiteLift PRO lateral to the involved leg, align the patient's greater
trochanter to the + symbol of the LiteLift PRO's hip axis (Fig. 17, Pos. 6).
KNEE AxIS
(HIDDEN)
CALF LENGTH
ADJUSTMENT KNOB
(HIDDEN)
FOOT PLATE
SUPPORT BAR
å ç
CALF SUPPORT BAR
ADJUSTMENT KNOB
(HIDDEN)
CALF SUPPORT
BAR
ACTUATOR ASSEMBLy
FOOT PLATE
ADJUSTMENT KNOB
é è
FOOT PLATE
FOOT PLATE
CONNECTION
PRO CONTROLLER
CORD CONNECTOR
ê ë
POST TUBE
DOUBLE CLAMP
TRACTION BAR
CLUTCH ASSEMBLy
POWER SWITCH
POWER SUPPLy
CONNECTOR
13