Table of Contents
Advertisement
Fig. 27
Adjust Foot Plate position by pulling on Foot Plate Adjustment Knob (Fig. 25, Pos. 1, page 16; Fig. 27) so that the ankle
is flexed appropriately and the toes are pointing at the ceiling.
Tighten all knobs and then run the LiteLift PRO through several cycles to ensure proper alignment and patient comfort.
Finally, make sure the PRO Controller is in Patient Mode and show patient how to operate LiteLift PRO with the PRO
Controller (see section 7.0).
Note!
We recommend that patients using the LiteLift PRO are checked at least once every shift—or anytime the
patient removes and reapplies device—to ensure that they are properly aligned and secured.
5.6 Changing Orientation of Foot Plate
The Foot Plate is designed to work on both left and right sides, with the Support Bar lateral to the patient's leg when
in use. To switch sides, first loosen Foot Plate Knob and remove Plate (Fig. 28). Next, loosen Support Bar Connection
Knob (Fig. 29) just enough to slide Support Bar out. Flip Bar over, making sure to correctly engage lateral wings within
Support Bar Connection (Fig. 30). Finally, reattach Foot Plate.
Fig. 28
Fig. 29
Fig. 30
17
Advertisement
Table of Contents
