Table of Contents
Advertisement
4.3.1 Attaching LiteLift® PRO to bed
Fig. 5
To attach the LiteLift® PRO to bed, first attach the smooth, round side of the Double Clamp to the Post Tube (Fig. 5).
Then attach the octagonal side of Double Clamp to bed's horizontal Traction Bar. The Traction Bar must have a flat
surface facing up. Securely tighten both sides of the clamp.
Fig. 6
The post tubes should be long enough to allow the unit to rest above the mattress a minimum of 8˝ (20cm) (Fig. 6).
Because the Traction Bars on different hospital beds are not all the same height above the mattress, it may be necessary
to add optional extensions to the Post Tube to obtain enough height. To add an extension, unscrew the Post Cap and
replace it with a Post Tube Extension. Screw the Post Tube Extension onto the Joint and screw the Post Cap into the top
of the Post Tube Extension.
4.3.2 Raising and Storing LiteLift PRO while attached to bed
Danger!
Failure to observe the following safety instructions can lead to injury of patient or hospital staff.
Danger!
DO NOT engage the Clutch Release if the CPM Device is not fully supported.
Danger!
Hospital staff must support the CPM Device with at least one hand when lowering the device to the bed.
Danger!
Always store the CPM Device in a vertical position.
10
Advertisement
Table of Contents
