Table of Contents
Advertisement
Time, Date, Operating Language, Screen Brightness, Volume and Warm-up Mode can be changed within the System
Settings Screen (Fig. 49, page 27). To make changes, scroll to the desired setting and select. Scroll within the selection
boxes to select the desired settings.
The Warm-Up Mode (Fig 49, Pos. C, page 27) offers several options. "Always run" begins any session with the Warm-Up
Mode. "Never run" eliminates the Warm-Up Mode. "Ask to run" asks the users at the beginning of each session if the
Warm-Up Mode is desired. See section 5.7 for more information about the Warm-Up Mode.
The System Settings Screen also provides information on Total System Cycles (Fig. 49, Pos. E, page 27) and which
version of Firmware version it is using.
6.2.7 Warm-Up Mode
Fig. 50
Knee Joint Setup
Warm-up Mode
Pop-up Window
The Warm-Up Mode has several settings which are set by the Clinical Professional: "Ask to run," Always run," and
"Never Run." If the Clinical Professional has selected "Ask to run," a pop-up window will appear whenever the device is
run for the first time after being powered on (Fig. 50). The patient can select yes or no using the PRO Controller right or
left Direction Keys and then select it with the Select Key.
Fig. 51
Knee Joint Setup
Warm-up Mode
indicator arrow
Warm-Up Mode begins at 25% less than the patient's set limits for both flexion and extension, and expands to 100% of
the patient's set limits over a period of 10 cycles. The patient can view an arrow (Fig. 51), which slowly fills up with black
as the cycles progress. The patient can disable the Warm-Up Mode by stopping the device and then immediately starting
it again.
28
Flexion
Force
Pause
Do you want to run
Warm-up?
Yes
No
Speed
Extension
Flexion
Force
Pause
Speed
Force
Pause
Speed
Extension
Angle Display
Warm-up Status Arrow
Advertisement
Table of Contents
