Table of Contents
Advertisement
Chapter 6: Installing the GS970EMX/10 Switch on a Wall
Installation Guidelines
78
Here are the guidelines to installing the GS970EMX/10 Switch on a wall:
As shown in Figure 41 on page 76 and Figure 42 on page 77, the
BRKT-J23 wall brackets secure the device by its sides. Installing
the brackets over the front or rear panel will block copper ports or
the AC power connector.
Installing the switch with two brackets requires one BRKT-J23
brackets kit. Installing the switch with four brackets requires two
BRKT-J23 brackets kits.
The BRKT-J23 brackets kit does not include screws or wall
anchors.
You can install the switch on a wooden or concrete wall.
The diameter of the screw holes in the brackets is 4mm.
You should not install the switch on only sheetrock or similar
material. Sheetrock might not be strong enough to safely support
the device.
Warning
The device should be installed on a wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.
E105
Warning
The device is heavy. Use both hands to lift it. You might injure
yourself or damage the device if you drop it. E94
Advertisement
Table of Contents
