Allied Telesis CentreCOM GS970EMX Series Installation Manual page 24

Chapter 1: Overview
24
Table 1. Specifications of the 10/100/1000Mbps Copper Ports (Continued)
Feature
Additional Features
For port pinouts, refer to "RJ-45 Copper Port Pinouts" on page 125.
Note
Copper ports must be set to Auto-Negotiation, the default, to
function at 1000Mbps. The network devices must be IEEE 802.3u
compliant.
Note
Copper ports that are connected to devices that do not support
Auto-Negotiation should not use Auto-Negotiation to set speed and
duplex mode. Otherwise, a speed or duplex mode mismatch might
occur between the devices, resulting in reduced performance. You
should set speed and duplex mode manually on copper ports that
are connected to devices that do not support Auto-Negotiation.
Description
Additional features are listed here:
- 8-pin RJ-45 connectors
- Backpressure flow control supported at half-
duplex mode
- Non-blocking, wire speed supported at all
speeds.
- Jumbo frames up to 12288 bytes
- 2MB packet buffer