Installation Guidelines - Allied Telesis GS970EMX/10 Installation Manual

Chapter 4: Installing the GS970EMX/10 Switch on a Wall

Installation Guidelines

62
Here are the guidelines to installing the switch on a wall:
 As shown in Figure 25 on page 60 and Figure 26 on page 61, the
BRKT-J23 brackets secure the device by its sides. Installing the
brackets over the front or rear panel will block copper ports or the
AC power connector.
 Installing the switch with two brackets requires one BRKT-J23
bracket kit. Installing the switch with four brackets requires two
BRKT-J23 bracket kits.
 The BRKT-J23 bracket kit does not include screws or wall anchors.
 You can install the switch on a wooden or concrete wall.
 The diameter of the screw holes in the brackets is 4mm.
 You should not install the switch only on sheetrock or similar
material. Sheetrock might not be strong enough to safely support
the device.
Warning
The device should be installed on a wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall. 
E105
Warning
The device is heavy. Use both hands to lift it. You might injure
yourself or damage the device if you drop it.  E94