Installation Guidelines - Allied Telesis x330 Series Installation Manual

Chapter 6: Installing the x330-10GTX Switch on a Wall

Installation Guidelines

78
Here are the guidelines to installing the switch on a wall:
As shown in Figure 41 on page 76 and Figure 42 on page 77, the

BRKT-J23 brackets secure the device by its sides. Installing the
brackets over the front or rear panel will block copper ports or the
AC power connector.
Installing the switch with two brackets requires one BRKT-J23

bracket kit. Installing the switch with four brackets requires two
BRKT-J23 bracket kits.
The BRKT-J23 bracket kit does not include screws or wall anchors.

You can install the switch on a wooden or concrete wall.

The diameter of the screw holes in the brackets is 4mm.

You should not install the switch only on sheetrock or similar

material. Sheetrock might not be strong enough to safely support
the device.
Warning
The device should be installed on a wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall. 
E105
Warning
The device is heavy. Use both hands to lift it. You might injure
yourself or damage the device if you drop it.  E94