Table of Contents
Advertisement
The illustration in the procedure shows the GS970EMX/28 Switch. The
procedure is the same for all GS970EMX Switches.
Note
Bumper feet are required for tabletop installation. They promote
cooling by allowing airflow beneath the switch.
To install the switch on a table, perform the following procedure:
1. Verify that the selected site is suitable for the unit by reviewing
"Reviewing Safety Precautions" on page 40 and "Choosing a Site for
the Switch" on page 44.
2. Verify that the table is strong enough to support the weight of the
switch.
3. Verify that the accessory kit came with all the appropriate items. Refer
to "Unpacking the Switch" on page 46.
4. Lift the switch from the shipping box and place it upside down on the
table.
5. Attach the four bumper feet to the bottom corners of the switch using
the four 3x4.5mm screws and a Phillips-head screwdriver. Refer to
Figure 25.
Figure 25. Attaching the Bumper Feet
6. Turn the switch over, placing it on the bumper feet.
7. Go to Chapter 8, "Verifying the Switch" on page 95.
CentreCOM GS970EMX Series Installation Guide for Standalone Switches
55
Advertisement
Table of Contents
