Table of Contents
Advertisement
3. Select the Control Mode Menu by pressing
4. Select LCD Interface mode by pressing
You can now execute commands in the Maintenance Menu.
7.2.1.2
SCSI Interface Mode
In the SCSI Interface mode, the host computer system issues SCSI commands to
the tape library to specify how cartridges are loaded and unloaded from the
removable cartridge holder and to access the tape drives.
To get the tape library to SCSI Interface mode:
1. Disable security.
2. Select the Interface Menu by pressing
3. Select the Control Mode Menu by pressing
4. Select SCSI Interface by pressing
7.2.1.3
Sequential 1, Sequential 2, or Dual Sequential Modes
Set the tape library to Sequential 1, Sequential 2, or Dual Sequential
mode in order to run the SunDiag system exerciser. If only one tape drive is
installed, only Sequential 1 mode is displayed.
1. Check to see if there are any tapes in the tape drives by checking LED states (refer
to LED descriptions in Section 6.7, "Tape Drive LEDs").
If there are tapes in the tape drives, you must remove them.
If a tape is installed in a tape drive:
a. Open the door.
b. Push the square-shaped Eject button to the right of the LEDs on the tape drive.
The tape unloads from the tape drive. The tape library ignores the fixed slot in all
sequential modes.
c. Close the door.
7-4
Sun StorEdge L400 Installation and User's Guide • April 1998
↓
↑
or
, then Enter.
↓
↑
or
, then Enter.
↓
↑
or
, then Enter.
↓
↑
or
, then Enter.
↓
↑
or
, then Enter.
Advertisement
Table of Contents
