Cycle L Axis Test; Cycle Solenoid Test - Sun Microsystems StorEdge L400 Installation And User Manual

4. Select the number of cycles (in increments of ten) you want the Cycle S Axis
test to run by pressing
The test positions the CHM in front of the fixed cartridge slot and moves the CHM
back and forth on the short axis the number of times you specify.
To abort this diagnostic, press Escape and Enter.
7.4.3.12

Cycle L Axis Test

The Cycle L Axis test moves the CHM back and forth on the long axis the
number of times you specify.
1. Select the Maintenance Menu by pressing
2. Select the Diagnostics Menu by pressing
3. Select Cycle L Axis by pressing
The system displays this screen:
Set Cycles
↑ Increase
↓ Decrease
4. Select the number of cycles (in increments of ten) you want the Cycle L Axis
test to run. Press
The test positions the CHM in front of the fixed cartridge slot and moves the CHM
back and forth on the long axis the number of times you specify.
To abort this diagnostic, press Escape and Enter.
7.4.3.13

Cycle Solenoid Test

The Cycle Solenoid test exercises the solenoid that controls the locking
mechanism on the front door.
1. Select the Maintenance Menu by pressing
2. Select the Diagnostics Menu by pressing
7-22 Sun StorEdge L400 Installation and User's Guide • April 1998
↑ ↓
or , then Enter.
↓
or
10
↑ ↓
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↑
, then Enter.
↓ ↑,
or then Enter.
↓ ↑
or , then Enter.