M To Find An Array By A Unit Id Assigned To The Esm(S) - Sun Microsystems StorEdge D2 Array Installation, Operation And Service Manual

7. Before leaving the Identify page turn off the LED(s).
a. Scroll to the bottom of the D2 Identify section.
b. Click on the applicable link(s) as shown in the following screen example.
M To Find an Array by a Unit ID assigned to the
ESM(s)
1. Go to the Network Storage Agent's Identify D2 page.
If needed, see "To Bring up the Network Storage Agent Maintain Devices Page" on
page 3-9 and "To Find a Disk's Device Name and SCSI ID on an Update D2 Page" on
page 3-10.
2. Find the Unit ID in the information at the top of the page.
Note – The Unit ID must be set as described in Step 2 on page 6.
3. Locate the Unit ID on the map created in Step 8 on page 4.
3-14 Sun StorEdge D2 Array Installation, Operation, and Service Manual • February 2002
3
Unit ID